Gloss Gel Problem.... Which one and where to buy?

I had been searching everywhere for gloss gel that mentioned by Ms Anis earlier,

But there is just too much of gloss gel in the market and I'm not sure which one is it...

The picture above is the one that my friend found it for me, not sure it is the one or not,

So I didn't buy it..

Here goes another problem.... I found all these different gloss gel at craft heaven in Bandar Utama...

WHICH ONE IS IT???

Should I buy all of these to try one by one? Only when there is a sample for me... In my dream, there's not going to happen... It's too expensive for me to purchase all of these...

 Lastly, is this the one that can repair the cardboard gap? I'm not so sure either... Need to ask ms anis in the next consultation...

2nd Prototype

Here is my second prototype, as I said before, this time I'm using cork craft board to replace the cardboard. I did the same steps like before, I cut it into pieces, but the sides are difficult to cut off and the cork flakes are keep falling off... Not that good as I was expected.

After all the cutting work, I started to paint the sides to cover the ugly parts but the result is very bad. It is because the paint is hardly dry, even its dry, I still can feel the stickyness of the paint when I touched it. The paint is keeps fading off whenever I hold it, this is much worse than I tot...

Although the paint can cover the sides of the cork board, but there is another huge problem. The sides was very ugly, the rough surface make it looks the puzzle is in very poor quality and the part that I can't stand it was the cork flakes are keep falling off. 

The conclusion is cork craft board is not a good material for my project, so far cardboard is still the best.

Feedback #1st Tryout

After I've consultation with Ms Anis and told her what's the problems that I'm facing now,

she suggested that I can use glossy gel to replace the glossy spray and paint.

She said I can get it from Spotlight Ampang Point,

it's a place that sell lots of craft thingy.

I haven't figure it out how to go there yet,

it's very far distance from my place (batu caves).

I'm thinking of going some DIY shops that near my place first before I go Spotlight,

so I can save my time and petrol.... 

For now, I'm doing my 2nd prototype using cork craft board.

Although Ms Anis said the cardboard is just good enough,

but trying another material may find something better.